![]() ![]() The F360 PlasmaC post processor includes "P190 Pn" in the Gcode where "n" is the tool number that was selected in F360. ![]() The only important parameter used from the F360 tool table is kerf as this will be embedded in the Gcode paths. I should be able to import the SheetCAM Powermax 65 Toolset (from /plasmac/39635-hypertherm-powerma圆5-toolset) using materialverter which will populate the PlasmaC material file.ģ) The PlasmaC material file will have a kerf entry for each material but this is not used at all (except for conversational & straight line cuts generated by PlasmaC).Ĥ) I should have a tool table in F360 that contains a numbered entry to match each numbered material in the PlasmaC material file. So based on the discussions in this thread is my understanding correct:ġ) Don't use cutter compensation (G41.1/G42.1)Ģ) PlasmaC will have a material file for all material types & thicknesses which contains speeds, kerf etc. It is very much appreciated as well as all the work you have put into PlasmaC. Thanks heaps for all the answers Phil & Rod. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |